CGC TACKLE DRYDOCK REPAIRS CGC-TACKLE-DRYDOCK-REPAIRS

The U.S. Coast Guard is looking for sources which would be interested in performing DRYDOCK repairs for Coast Guard Cutter TACKLE (WYTL 65604). USCGC TACKLE (WYTL 65604) is a 65 Foot Small Harbor Tug. ANTICIPATED PERIOD OF PERFORMANCE: The performance period of this upcoming DRYDOCK is 21 October 2025 to 15 December 2025. The scope of the acquisition is for the drydock repairs of various work items for the USCGC TACKLE. This work will include, but is not limited to: Fire Prevention Requirements TYPE Hull Plating, U/W Body, Inspect Hull Plating, U/W Body, Ultrasonic Testing Hull Plating, Freeboard, Ultrasonic Testing U/W Body, Preserve, 100 percent U/W Body, Preserve, Partial, Condition A U/W Body, Preserve, Partial, Condition B U/W Body, Preserve, Partial, Condition C Hull Plating Freeboard, Preserve, Partial Hull Plating Freeboard, Preserve, 100 Percent Hull and Structural Plating, General, 10.2 lbs. Steel, Renew Hull and Structural Plating, General, 12.75 lbs. Steel Plate, Renew Hull and Structural Plating, General, 15.3 lbs. Steel Plate, Renew Hull And Structural Plating, General, 20.4 lbs. Steel Plate, Renew Hull and Structural Plating, General, 7.5 lbs., 3/16 in. Steel Plate, Renew Hull and Structural Plating, General, 7.65 lbs. Steel Plate, Renew Hull And Structural Plating, General, Cracked Steel Welds, Repairs Hull and Structural Plating, General, Degraded Weld, Steel, Repair Appendages, U/W, Leak Test Appendages, U/W, Internal, Preserve Voids (Accessible, Weather Deck Exposed), Inspect Tanks, MP Fuel Service, Clean and Inspect - Tender Tanks, Potable Water, Clean and Inspect Propulsion Shafting, Strain Gage Alignment, Inspect Propulsion Shafting; Remove, Inspect, and Reinstall Propulsion Shafting, Straighten Propulsion Shaft Bearings, External, Check Clearances Propulsion Shaft Bearings (External), Renew Stern Tube Interior Surfaces, Preserve, 100 Percent Propeller , Clean And Inspect Propeller , Remove, Inspect, and Reinstall Propeller, Minor Repairs and Reconditioning, Perform Keel Coolers, Clean, Inspect and Hydro Main Diesel Engine, MDE, Exhaust Piping, Commercial Clean Ship Service Diesel Generator, SSDG, Exhaust Piping, Commercial Clean Boiler Exhaust Stack Uptakes, Commercial Clean Fathometer Transducer, Renew Vent Ducts, Engine And Motor Room, All, Commercial Cleaning Sea Valves and Waster Pieces, Overhaul Or Renew Sea Strainers, Duplex, All Sizes, Overhaul Hot Water Accumulator Tanks, Clean and Inspect Compressed Air Receivers and System Valves, All, Clean, Inspect, Hydro and Lift Rudder Assembly, Remove, Inspect And Reinstall Rudders, Preserve, 100 Percent Rudder Stock Bearings Clearances, Check Rudder Stock, Rebuild Hull Fittings (Mooring and Towing), Inspect and Test Boat Davit, Inspect and Service Sewage Holding Tanks, Clean and Inspect Grey Water Piping, Clean and Flush Sewage Piping, Clean and Flush Tanks (Sewage Holding), Preserve, Partial Tanks, Potable Water, Preserve, Partial Cathodic Protection, Zinc Anodes, Renew Drydock Temporary Services, Provide - Tender Sea Trial Performance, Support, Provide Bilges, Preserve Deck Covering, Interior, Wet and Dry, Renew Lead Dust, Clean Ship Structures, Inspect for Presence of Lead-Based Paint Lead-Based Paint and Asbestos-Containing Material, Perform Partial Abatement Lead-Based Paint and Asbestos-Containing Material, Perform Spot Abatement Lead-Based Paint, Perform Spot Abatement Alarms, Halon Pre-discharge, Modify Small Boat Cradle, Preserve Cargo Hold Structural Repair Frame Repair Crews Berthing Multi-Cable Transit, Renew Multi-Cable Transit Engine Room, Renew Sewage System Piping, Renew Emergency Lighting Fixtures, Replace Companies which would be interested in submitting a proposal for this requirement should reply to this sources sought notice noting their business size status such as large business, small business, HUBZone, Service-Disabled Veteran-owned, Women Owned Small Business etc . Replies should be sent by 11 July 2025, 10:00 am Eastern Standard Time to: Iran.N.Walker@uscg.mil Shortly after receiving responses the Coast Guard will determine if this requirement will be set aside or unrestricted. After the determination a combined synopsis/solicitation will be posted on this website (https://www.sam.gov). The NAICS Code is 336611. The small business size standard is less than 1300 employees. Contractors are reminded that in the case of a HUB Zone set-aside, FAR 52.219-3, "Notice of HUBZone Set-Aside or Sole Source Award" would apply which requires that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern or employees of other HUBZone small businesses. Contractors are also reminded that in the case of a Service-Disabled Veteran-Owned Small Business Set-Aside, FAR 52.219-27, "Notice of Service-Disabled Veteran-Owned Small Business Set-Aside" would apply which requires that at least 50 percent of the cost of personnel for contract performance be spent for employees of the concern or employees of other service-disabled veteran owned small businesses. Additionally, regarding FAR 52.219-30 "Notice of Set A-Side For Women-Owned Small Business Concerns ": A women-owned small business (WOSB) concern eligible under the WOSB Program, means a small business concern that is at least 51 percent directly and unconditionally owned by, and the management and daily business operations of which are controlled by, one or more women who are citizens of the United States. Primary Point of Contact: Iran Walker, Iran.N.Walker@uscg.mil Phone: (757) 628-4563