25--Truck Bed and Installation 140D0425Q0423

****SOLICITATION RESPONSE DATE EXTENDED TO 15 JUNE @ 1700 EDT**** This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; quotes are being requested and a written solicitation will not be issued. Note: This acquisition is subject to the availability of funds. INTRODUCTION: The AFCEC has a requirement to upgrade a 2024 Chevy 5500 (International Model GM515) truck with a new steel utility truck bed. The Government is seeking a contractor to provide and install a new steel utility truck bed on the vehicle as specified below. The AQD is issuing this competitive RFQ as 100% set aside for small business. OVERVIEW OF THE REQUIREMENT: This acquisition is to provide and install the exact required commercial end item of supply with the required specifications below on or before September 1, 2025. The Government intends to drop-off and pick-up the vehicle at the location of installation given the driving distance does not exceed 100 miles from the address below: AFWFB 1 NORAD Rd, Bldg 307 Colorado Springs, CO 80914 Vehicle Specifications: VIN: 1HTKJPVK2RH109005 Model Year: 2024 Make: Chevrolet Model: 5500 (International Model GM515) Build Date: November 2024 Cab to Axle: 63 inches Bed Length: 9 feet 4 inches Width: 92 inches Runner Width: 34 inches Service Truck Bed Specifications and Requirements: The service truck bed to be procured and installed must meet or exceed the following specifications: Dimensions & Structural Requirements: Length: 9 feet 4 inches Width: Minimum 90 inches Frame Material: Structural steel, painted black Headache Rack: Notched design with steel tube and cross bars Flooring: 1/8 inch steel, tread plate or diamond plate Frame Rails: 4 inch structural channel steel Crossmembers: 3 inches x 3/16 inch channel steel Functional Components: Tailgate: Fold-down design with latch Fuel Access: Angled fuel filler Tool Storage: 2 front-mounted toolboxes 2 rear-mounted toolboxes 2 horizontal toolboxes Towing & Electrical: Rear Bumper: Rated for 18,000+ lbs with 2 ½ inch receiver hitch Gooseneck Hitch: 30,000 lb-rated 2 5/16 inch ball Wiring: 7-pin plug in gooseneck well 7-pin female receiver plug with adapter Lighting & Accessories: All lighting must meet DOT standards Integrated license plate mount Mudflap brackets included Installation Requirements: The selected vendor will be responsible for the full installation of the service bed onto the identified vehicle. Installation must comply with all applicable safety standards, and all wiring, fuel access points, and hitch components must be fully functional and tested prior to delivery.